SN74LVCH16T245DGVR屬于集成電路（IC）的轉換器電平移位器。由美國德州儀器公司制造生產的SN74LVCH16T245DGVR轉換器，電平移位器邏輯轉換器或電平移位器 IC 可用于在數字邏輯設備之間傳遞信息，這些設備可在不同/不兼容的供電電壓下工作，或可實現不同的信令方式。例如，可以將需要 5 V 電源的數字輸出傳感器連接到具有 3.3 V I/O 電源的 FPGA，或者在 CMOS 或 TTL 等單端信令方式與 PECL 或 LVDS 等差分技術之間進行轉換。

1 Features

1? Control Inputs VIH/VIL Levels are Referenced to

V CCA Voltage

? VCC Isolation Feature – If Either VCC Input is at

GND, All Outputs are in the High-Impedance State

? Overvoltage-Tolerant Inputs and Outputs Allow

Mixed-Voltage-Mode Data Communications

? Fully Configurable Dual-Rail Design Allows Each

Port to Operate Over the Full 1.65 V to 5.5 V

Power-Supply Range

? Bus Hold on Data Inputs Eliminates the Need for

External Pullup and Pulldown Resistors

? Ioff Supports Partial-Power-Down Mode Operation

? Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

? ESD Protection Exceeds JESD 22

2 Applications

? Personal Electronics

? Industrial

? Enterprise

? Telecom

3 Description

This 16-bit noninverting bus transceiver uses two

separate configurable power-supply rails. The A port

is designed to track VCCA. VCCA accepts any supply

voltage from 1.65 V to 5.5 V. The B port is designed

to track VCCB. VCCB accepts any supply voltage from

1.65 V to 5.5 V. This allows for universal low-voltage

bidirectional translation between any of the 1.8-V,

2.5-V, 3.3-V, and 5-V voltage nodes.

The SN74LVCH16T245 device control pins (1DIR,

2DIR, 1OE, and 2OE) are supplied by VCCA.

The SN74LVCH16T245 device is designed for

asynchronous communication between two data

buses. The logic levels of the direction-control (DIR)

input and the output-enable (OE) input activate either

the B-port outputs or the A-port outputs or place both output ports into the high-impedance mode. The

device transmits data from the A bus to the B bus

when the B-port outputs are activated, and from the B

bus to the A bus when the A-port outputs are

activated. The input circuitry on both A and B ports is always active and must have a logic HIGH or LOW

level applied to prevent excess ICC and ICCZ.