描述 Description

The 'ABT16374A are 16-bit edge-triggered D-type flip-flops with 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers. These devices can be used as two 8-bit flip-flops or one 16-bit flip-flop. On the positive transition of the clock (CLK) input, the Q outputs of the flip-flop take on the logic levels set up at the data (D) inputs. A buffered output-enable (OE\\) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components OE\\ does not affect internal operations of the flip-flop. Old data can be retained or new data can be entered while the outputs are in the high-impedance state. When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver. The SN54ABT16374A is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT16374A is characterized for operation from -40°C to 85°C.

特性 Features

? Members of the Texas InstrumentsWidebusTM Family
? State-of-the-ArtEPIC-II BTM BiCMOS Design Significantly Reduces Power Dissipation
? ESD Protection Exceeds 2000 V Per MIL-STD-883, Method 3015
? Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD-17
? Typical VOLP (Output Ground Bounce) CC = 5 V, TA = 25°C
? High-Impedance State During Power Up and Power Down
? Distributed VCC and GND Pin Configuration Minimizes High-Speed Switching Noise
? Flow-Through Architecture Optimizes PCB Layout
? High-Drive Outputs (-32-mA IOH, 64-mA IOL)
? Package Options Include Plastic 300-mil Shrink Small-Outline (DL) and Thin Shrink Small-Outline (DGG) Packages and 380-mil Fine-Pitch Ceramic Flat (WD) Package Using 25-mil Center-to-Center Spacings Widebus and EPIC-IIB are trademarks of Texas Instruments Incorporated.