UCC384DP-ADJG4屬于集成電路（IC）的線性+開關穩壓器。由美國德州儀器公司制造生產的UCC384DP-ADJG4穩壓器 - 線性線性穩壓器用于提供穩定的輸出電壓，無論負載電流、輸入電壓或環境因素如何變化，這些輸出電壓通常都要保持不變。它們的工作原理要求輸入電壓維持在高于所需的輸出電壓，而且要超出某個最小量，并且在工作時會將輸入端的任何多余電壓轉換為熱量。對于大多數應用而言，雖然這種穩壓器的效率低于開關模式的穩壓器，但它們通常更適合對噪聲高度敏感的應用。

Precision Negative Series Pass Voltage

Regulation

0.2 V Dropout at 0.5 A

Wide Input Voltage Range –3.2 V to –15 V

Low Quiescent Current Irrespective of Load

Simple Logic Shutdown Interfacing

–5 V, –12 V, and Adjustable Output

2.5% Duty Cycle Short Circuit Protection

description

The UCC384-x family of negative linear-series pass regulators is tailored for low-dropout applications where

low-quiescent power is important. Fabricated with a BCDMOS technology ideally suited for low input-to-output

differential applications, the UCC384-x passes 0.5 A while requiring only 0.2 V of input-voltage headroom.

Dropout voltage decreases linearly with output current, so that dropout at 50 mA is less than 20 mV.

Quiescent current consumption for the device under normal (non-dropout) conditions is typically 200 μA. An

integrated charge pump is internally enabled only when the device is operating near dropout with low VIN. This

ensured that the device meets the dropout specifications even for maximum load current and a VIN of –3.2 V

with only a modest increase in quiescent current. Quiescent current is always less than 350 μA, with the charge

pump enabled. The quiescent current of the UCC384 does not increase with load current.

Short-circuit current is internally limited. The device responds to a sustained overcurrent condition by turning

off after a tON delay. The device then stays off for a period, tOFF, that is 40 times the tON delay. The device then

begins pulsing on and off at the tON/tOFF duty cycle of 2.5%. This drastically reduces the power dissipation during

short circuit such that heat sinking, if at all required, must only accommodate normal operation. An external

capacitor sets the on time. The off time is always 40 times tON.

The UCCx84-x can be shutdown to 45 μA (maximum) by pulling the SD/CT pin more positive than –0.7 V. To

allow for simpler interfacing, the SD/CT pin may be pulled up to 6 V above the ground pin without turning on

clamping diodes.

Internal power dissipation is further controlled with thermal-overload protection circuitry. Thermal shutdown

occurs if the junction temperature exceeds 140°C. The chip remains off until the temperature has dropped 20°C

(TJ = 120°C).