UCC383TDTR-3屬于集成電路（IC）的線性+開關穩壓器。由美國德州儀器公司制造生產的UCC383TDTR-3穩壓器 - 線性線性穩壓器用于提供穩定的輸出電壓，無論負載電流、輸入電壓或環境因素如何變化，這些輸出電壓通常都要保持不變。它們的工作原理要求輸入電壓維持在高于所需的輸出電壓，而且要超出某個最小量，并且在工作時會將輸入端的任何多余電壓轉換為熱量。對于大多數應用而言，雖然這種穩壓器的效率低于開關模式的穩壓器，但它們通常更適合對噪聲高度敏感的應用。

Precision Positive Linear Series Pass

Voltage Regulation

0.45 V Dropout at 3 A

50 mV Dropout at 10 mA

Quiescent Current Under 650 μA

Irrespective of Load

Adjustable (5-Lead) Output Voltage Version

Fixed (3-Lead) Versions for 3.3-V and 5-V

Outputs

Logic Shutdown Capability

Short-Circuit Power Limit of

(3% × VIN × ISHORT)

Low VOUT to VIN Reverse Leakage

Thermal Shutdown

description

The UCC283?3/?5/?ADJ family of positive linear

series pass voltage regulators are tailored for

low-drop-out applications where low quiescent

power is important. Fabricated with a BiCMOS

technology ideally suited for low input-to-output

differential applications, the UCC283?5 passes

3 A while requiring only 0.45 V of typical input

voltage headroom (ensured 0.6-V dropout).

These regulators include reverse voltage sensing that prevents current in the reverse direction. Quiescent

current is always less than 650 μA. These devices have been internally compensated in such a way that the

need for a minimum output capacitor has been eliminated.

UCC283?3 and UCC283?5 versions are in 3-lead packages and have preset outputs at 3.3 V and 5.0 V

respectively. The output voltage is regulated to 1.5% at room temperature. The UCC283?ADJ version, in a

5-lead package, regulates the output voltage programmed by an external resistor ratio.

Short-circuit current is internally limited. The device responds to a sustained overcurrent condition by turning

off after a tON time delay. The device then stays off for a period, tOFF, that is 32 times the tON delay. The device

then begins pulsing on and off at the tON/(tON+tOFF) duty cycle of 3%. This drastically reduces the power

dissipation during short-circuit and means heat sinks need only accommodate normal operation. On the

3-leaded versions of the device tON is fixed at 750 μs, on the adjustable 5-leaded versions an external capacitor

sets the on time. The off time is always 32 × tON. The external timing control pin, CT, on the 5-leaded versions

also serves as a shutdown input when pulled low.

Internal power dissipation is further controlled with thermal overload protection circuitry. Thermal shutdown

occurs if the junction temperature exceeds 165°C. The chip remains off until the temperature has dropped 20°C.

The UCC283 series is specified for operation over the industrial range of ?40°C to 85°C, and the UCC383 series

is specified from 0°C to 70°C. These devices are available in 3- and 5-pin TO?220 and TO?263 power packages.