描述 Description

This one-bit non-inverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 V to 3.6 V. The B port is designed to track VCCB. VCCA must be less than or equal to VCCB. VCCB accepts any supply voltage from 2.3 V to 5.5 V. This allows for low voltage bidirectional translation between any of the 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.

When the output-enable (OE) input is low, all outputs are placed in the high-impedance state.

To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pull-down resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.

特性 Features

? Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
? ESD Protection Exceeds JESD 22
? A Port
? 2500 V Human-Body Model (A114-B)
? 200 V Machine Model (A115-A)
? 1500 V Charged-Device Model (C101)

? B Port
? 8 kV Human-Body Model (A114-B)
? 200 V Machine Model (A115-A)
? 1500 V Charged-Device Model (C101)


? No Direction-Control Signal Needed
? Maximum Data Rates
? 24 Mbps (Push Pull)
? 2 Mbps (Open Drain)

? Available in the Texas Instruments NanoFree? Package
? 1.65 V to 3.6 V on A port and 2.3 V to 5.5 V on B port (VCCA ?≤ VCCB)
? VCC Isolation Feature – If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
? No Power-Supply Sequencing Required – Either VCCA or VCCB Can be Ramped First
? Ioff Supports Partial-Power-Down Mode Operation