TS5V330CDBQR屬于集成電路（IC）的模擬開關-特殊用途。由美國德州儀器公司制造生產的TS5V330CDBQR模擬開關 - 特殊用途特殊用途模擬開關通過固態設備路由模擬信號。該系列產品的與眾不同之處在于，這些模擬開關針對特定的應用，因此具有通用模擬開關通常所沒有的獨特功能。

1FEATURES

? Low Differential Gain and Phase

(Typical DG = 0.24%, Typical DP = 0.039°)

? Wide Bandwidth (Typical BW > 288 MHz)

? Low Cross-Talk (Typical XTALK = –87 dB)

? Low Power Consumption

(Maximum ICC = 3 μA)

? Bidirectional Data Flow, With Near-Zero

Propagation Delay

? Low ON-State Resistance (Typical rON = 3 Ω)

? VCC Operating Range From 4.5 V to 5.5 V

? Ioff Supports Partial-Power-Down Mode

Operation

? Data and Control Inputs Provide Undershoot

Clamp Diode

? Control Inputs Can be Driven by TTL or

5-V/3.3-V CMOS Outputs

? Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

? ESD Performance Tested Per JESD 22

– 2000-V Human-Body Model

(A114-B, Class II)

– 1000-V Charged-Device Model (C101)

? Suitable for Both RGB and Composite Video

Switching

DESCRIPTION/ORDERING INFORMATION

The TS5V330C is a 4-bit 1-of-2 multiplexer/demultiplexer video switch with a single switch-enable (EN) input.

The select (IN) input controls the data path of the multiplexer/demultiplexer. When EN is low, the switch is

enabled and the D port is connected to the S port. When EN is high, the switch is disabled and a high impedance

state exists between the D and S ports.

Low differential gain and phase makes this switch ideal for video applications. The device has a wide bandwidth

and low cross talk which makes it suitable for high frequency video applications. The device can be used for

RGB and composite video switching applications.

This device is fully specified for partial-power-down applications using Ioff. The Ioff feature ensures that damaging

current will not backflow through the device when it is powered down. The device has isolation during power off.

To ensure the high-impedance state during power up or power down, EN should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.