描述 Description

The TRS3223 consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The device operates at data signaling rates up to 250 kbit/s and a maximum of 30-V/μs driver output slew rate. Flexible control options for power management are available when the serial port is inactive. The auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is set low and EN is high, both drivers and receivers are shut off, and the supply current is reduced to 1 μA. Disconnecting the serial port or turning off the peripheral drivers causes auto-powerdown to occur. Auto-powerdown can be disabled when FORCEON and FORCEOFF are high. With auto-powerdown enabled, the device is activated automatically when a valid signal is applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than ?2.7 V, or has been between ?0.3 V and 0.3 V for less than 30 μs. INVALID is low (invalid data) if the receiver input voltage is between ?0.3 V and 0.3 V for more than 30 μs. See Figure 4 for receiver input levels.

特性 Features

? Qualified for Automotive Applications
? RS-232 Bus-Pin ESD Protection Exceeds ±15 kV Using Human-Body Model (HBM)
? Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards
? Operates With 3-V to 5.5-V VCC Supply
? Operates up to 250 kbit/s
? Two Drivers and Two Receivers
? Low Standby Current . . . 1 μA Typical
? External Capacitors . . . 4 × 0.1 μF
? Accepts 5-V Logic Input With 3.3-V Supply