GENERAL DESCRIPTION

The TDA10021HT is a single-chip DVB-C channel receiver for 4, 16, 32, 64, 128 and 256 QAM modulated signals. The device interfaces directly to the IF signal, which is sampled by a 10-bit ADC.

FEATURES

? 4, 16, 32, 64, 128 and 256 Quadrature Amplitude Modulation (QAM) demodulator (DVB-C compatible: ETS 300-429/ITU-T J83 annex A/C)

? High performance for 256 QAM, especially for direct IF applications

? On-chip 10-bit Analog-to-Digital Converter (ADC)

? On-chip Phase-Locked Loop (PLL) for crystal frequency multiplication (typically 4 MHz crystal)

? Digital downconversion

? Programmable half Nyquist filter (roll off = 0.15 or 0.13)

? Two Pulse Width Modulated (PWM) AGC outputs with programmable take over point (for tuner and downconverter control)

? Clock timing recovery, with programmable 2nd-order loop filter

? Variable symbol rate capability from SACLK/64 to SACLK/4 (SACLK = 36 MHz maximum)

? Programmable anti-aliasing filters

? Full digital carrier recovery loop

? Carrier acquisition range up to 18 of symbol rate

? Integrated adaptive equalizer (linear transversal equalizer or decision feedback equalizer)

? On-chip Forward Error Correction (FEC) decoder (de-interleaver and RS decoder) and fully DVB-C compliant

? DVB compatible differential decoding and mapping

? Parallel and serial transport stream interface simultaneously

? I2C-bus interface, for easy control

? CMOS 0.2 μm technology.

APPLICATIONS

? Cable set-top boxes

? Cable modems

? MMDS (ETS 300-749) set-top boxes.