SN74ALVCH162827DL屬于集成電路（IC）的緩沖器驅動器接收器收發器。由美國德州儀器公司制造生產的SN74ALVCH162827DL緩沖器，驅動器，接收器，收發器邏輯緩沖器、驅動器、接收器和收發器允許隔離對某個電路的邏輯信號的訪問，以用于另一電路。緩沖器將其輸入信號（不變或反相）傳遞到其輸出，并可能用于清除弱信號或驅動負載。在布爾邏輯仿真器中，緩沖器主要用于增加傳播延遲。邏輯接收器和收發器允許在數據總線之間進行隔離通信。

FEATURES

· Member of the Texas Instruments Widebus?

Family

· Output Ports Have Equivalent 26-W Series

Resistors, So No External Resistors Are

Required

· Bus Hold on Data Inputs Eliminates the Need

for External Pullup/Pulldown Resistors

· Latch-Up Performance Exceeds 250 mA Per

JESD 17

· ESD Protection Exceeds JESD 22

- 2000-V Human-Body Model (A114-A)

- 200-V Machine Model (A115-A)

- 1000-V Charged-Device Model (C101)

DESCRIPTION/ORDERING INFORMATION

This 20-bit noninverting buffer/driver is designed for

1.65-V to 3.6-V VCC operation.

The SN74ALVCH162827 is composed of two 10-bit

sections with separate output-enable signals. For

either 10-bit buffer section, the two output-enable

(1OE1 and 1OE2 or 2OE1 and 2OE2) inputs must

both be low for the corresponding Y outputs to be

active. If either output-enable input is high, the

outputs of that 10-bit buffer section are in the

high-impedance state.

The outputs, which are designed to sink up to 12 mA,

include equivalent 26-W resistors to reduce overshoot

and undershoot.

To ensure the high-impedance state during power up

or power down, OE should be tied to VCC through a

pullup resistor; the minimum value of the resistor is

determined by the current-sinking capability of the

driver.

Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors

with the bus-hold circuitry is not recommended.