SN65LVDS117DGGR屬于集成電路（IC）的信號緩沖器、中繼器、分離器。由美國德州儀器公司制造生產的SN65LVDS117DGGR信號緩沖器、中繼器、分離器信號緩沖器、中繼器和分離器系列中的產品適用于遠距離電氣互連或電纜系統(tǒng)的數字信息傳輸。所有實際互連系統(tǒng)都具有非理想特性，該系列產品主要用于解決數字信息傳輸過程中因此造成的模擬問題。此外，還有其他功能，例如不同物理接口樣式之間的轉換和多路復用。

FEATURES

· Two Line Receivers and Eight ('109) or

Sixteen ('117) Line Drivers Meet or Exceed the

Requirements of ANSI EIA/TIA-644 Standard

· Typical Data Signaling Rates to 400 Mbps or

Clock Frequencies to 400 MHz

· Outputs Arranged in Pairs From Each Bank

· Enabling Logic Allows Individual Control of

Each Driver Output Pair, Plus All Outputs

· Low-Voltage Differential Signaling With

Typical Output Voltage of 350 mV and a 100-W

Load

· Electrically Compatible With LVDS, PECL,

LVPECL, LVTTL, LVCMOS, GTL, BTL, CTT,

SSTL, or HSTL Outputs With External

Termination Networks

· Propagation Delay Times < 4.5 ns

· Output Skew Less Than 550 ps Bank Skew

Less Than150 ps Part-to-Part Skew Less Than

1.5 ns

· Total Power Dissipation Typically <500 mW

With All Ports Enabled and at 200 MHz

· Driver Outputs or Receiver Input Equals High

Impedance When Disabled or With VCC < 1.5 V

· Bus-Pin ESD Protection Exceeds 12 kV

· Packaged in Thin Shrink Small-Outline

Package With 20-Mil Terminal Pitch

DESCRIPTION

The SN65LVDS109 and SN65LVDS117 are configured

as two identical banks, each bank having one

differential line receiver connected to either four

('109) or eight ('117) differential line drivers. The

outputs are arranged in pairs having one output from

each of the two banks. Individual output enables are

provided for each pair of outputs and an additional

enable is provided for all outputs.

The line receivers and line drivers implement the

electrical characteristics of low-voltage differential

signaling (LVDS). LVDS, as specified in EIA/TIA-644,

is a data signaling technique that offers low power,

low noise emission, high noise immunity, and high

switching speeds. (Note: The ultimate rate and distance

of data transfer is dependent upon the attenuation

characteristics of the media, the noise coupling

to the environment, and other system characteristics.)

The intended application of these devices, and the

LVDS signaling technique, is for point-to-point or

point-to-multipoint (distributed simplex) baseband data transmission on controlled impedance media of

approximately 100 W. The transmission media may

be printed-circuit board traces, backplanes, or cables.

The large number of drivers integrated into the same

silicon substrate, along with the low pulse skew of

balanced signaling, provides extremely precise timing

alignment of the signals being repeated from the

inputs. This is particularly advantageous for im-

plementing system clock and data distribution trees.

The SN65LVDS109 and SN65LVDS117 are

characterized for operation from –40°C to 85°C.