SN65LVDM051QDRG4Q1屬于集成電路（IC）的驅動器接收器收發器。由美國德州儀器公司制造生產的SN65LVDM051QDRG4Q1驅動器，接收器，收發器該系列產品的主要功能是提供必需的硬件資源，以通過延長電纜或印制線進行通信。確切的功能會因所采用的通信協議而異，可能包括諸如瞬態抑制之類的功能，這些功能對于通信用途可能并非絕對必要，但對于可能的使用環境卻是明智之選。

Qualified for Automotive Applications

ESD Protection Exceeds 2000 V Per

MIL-STD-883, Method 3015; Exceeds 200 V

Using Machine Model (C = 200 pF, R = 0)

Low-Voltage Differential 50-Ω Line Drivers

and Receivers

Signaling Rates up to 500 Mbps

Bus-Terminal ESD Exceeds 12 kV

Operates From a Single 3.3 V Supply

Low-Voltage Differential Signaling With

Typical Output Voltages of 340 mV With a

50-Ω Load

Valid Output With as Little as 50-mV Input

Voltage Difference

Propagation Delay Times

? Driver: 1.7 ns Typ

? Receiver: 3.7 ns Typ

Power Dissipation at 200 MHz

? Driver: 50 mW Typical

? Receiver: 60 mW Typical

LVTTL Input Levels Are 5 V Tolerant

Driver Is High Impedance When Disabled or

With VCC < 1.5 V

Receiver Has Open-Circuit Fail Safe

description

The SN65LVDM050, and SN65LVDM051 are differential line drivers and receivers that use low-voltage

differential signaling (LVDS) to achieve signaling rates as high as 500 Mbps (per TIA/EIA-644 definition). These

circuits are similar to TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts, except that the output

current of the drivers is doubled. This modification provides a minimum differential output voltage magnitude

of 247 mV across a 50-Ω load simulating two transmission lines in parallel. This allows having data buses with

more than one driver or with two line termination resistors. The receivers detect a voltage difference of 50 mV

with up to 1 V of ground potential difference between a transmitter and receiver.

The intended application of these devices and signaling techniques is point-to-point and multipoint, baseband

data transmission over a controlled impedance media of approximately 100 Ω of characteristic impedance. The

transmission media may be printed-circuit board traces, backplanes, or cables.