LTC9102屬于集成電路（IC）的以太網供電（PoE）控制器。由亞德諾半導體技術有限公司制造生產的LTC9102以太網供電（PoE）控制器以太網供電 (PoE) 控制器允許設計人員通過單個以太網連接傳輸電流和數據。遠程設備通過以太網電纜供電，因此無需電池、本地電源適配器和其他電源電纜。橋式整流器和 N+1 O-Ring 是兩種 PoE 控制器類型。可用特性可能包括 N 和 P 溝道 FET、內部開關和汽車認證。

FEATURES

? IEEE 802.3bt Powered Device (PD) Controller

? 400kHz I2C Interface

? Continuous Voltage, Current, and Power Telemetry

? Dedicated 14-Bit Delta-Sigma Current and Voltage ADCs

? Automatic Maintain Power Signature (MPS)

? Supports Up to 90W PDs with Extended Power

? 5-Event Classification Sensing with PSE Allocated Power Readback

? Seamless Switchover between Dual PD or PD/AUX Inputs

? Superior Surge Robustness (100V Absolute Maximum)

? Wide Junction Temperature Range (-40?C to 125?C)

? External Hot Swap N-Channel MOSFET for Lowest Power Dissipation

and Highest System Efficiency

? 50mΩ Current Sense Resistor

? Auxiliary Input Sense with Standby Modes

? 20-Pin 5mm x 5mm QFN Package

APPLICATIONS

? IEEE 802.3bt PDs with Power Telemetry

? Wireless Access Points/Pico Cells

? Internet Protocol (IP) Security Cameras

? Power over Ethernet (PoE) Lighting

DESCRIPTION

The LTC9105 is an IEEE 802.3af/at/bt (PoE 2) Power over

Ethernet (PoE) powered device (PD) controller with input current,

voltage, and power telemetry. The LTC9105 includes an I2C interface

to read telemetry, power sourcing equipment (PSE) allocated

power, and auxiliary input status, and to write power input priority.

The LTC9105 also features a configurable downstream power-up

disable with under-power indication when the PSE allocated power

is less than the PD requested power.

The LTC9105 utilizes an external, low RDS(ON), N-Channel, Hot

Swap MOSFET, and a 50mΩ current sense resistor, and supports

the LT4321 ideal bridge to extend the end-to-end power delivery efficiency.

Also included are a power good output, external signature

resistor, resistor programmable classification and pin-configurable

PD requested Class. The presence of an auxiliary power supply

is sensed at the AUX pin and reported through the I2C interface.

Automatic maintain power signature (MPS) circuitry keeps the PD

interface powered when downstream current draw falls below an

internal MPS threshold.

Two dedicated Delta-Sigma ADCs continuously measure PD controller

input voltage and current with a typical conversion time

of 100ms and with 14-bit resolution. Simultaneous conversion of

current and voltage measurements enables high-accuracy power

calculations.