最新无码a∨在线观看,一本av高清一区二区三区,亚洲熟妇色l20p,宅男噜噜69av,中出あ人妻熟女中文字幕

IPS160H

單個上橋臂開關，面向安全完整性等級（SIL2和SIL3）兼容系統; ? 8 V to 60 V operating voltage range \n? Minimum output current limitation: 0.7 A (IPS161H) or 2.5 A (IPS160H) \n? Fast demagnetization of inductive load \n? Non-dissipative short-circuit protection (cut-off) \n? Programmable cut-off delay time using external capacitor \n? Ground disconnection protection? VCC disconnection protection \n? Thermal shutdown protection \n? Undervoltage lock-out \n? Diagnostic signalization for: open load in off-state, cut-off and junction thermal shutdown \n? Designed to meet IEC 61131-2 \n? PowerSSO12 package;

The IPS160H (IOUT < 2.5 A) and IPS161H (IOUT < 0.7 A) are monolithic devices which can drive capacitive, resistive or inductive loads with one side connected to ground.\n\n The 60 V operating range and Ron = 60 mΩ, combined with the extended diagnostic (Open Load, Over Load, Overtemperature) make the IC suitable for applications implementing the proper architectures to address higher SIL levels. The built-in overload and thermal shutdown protections guarantee the ICs, the application and the load against electrical and thermal overstress. Furthermore, in order to minimize the power dissipation when the output is shorted, a low-dissipative short-circuit protection (cut-off) is implemented to limit the output average current value and consequent device overheating.Cut-off delay time can be set by soldering an external capacitor or disabled by a resistor on pin 4 (CoD). \n\n The DIAG common diagnostic open drain pin reports the open load in off-state, cutoff (overload) and thermal shutdown.\n\n

IPS160H

Single high-side switch

IPS160H

Package：12-PowerLSOP（0.154"，3.90mm 寬）；包裝：卷帶（TR）剪切帶（CT）Digi-Reel? 得捷定制卷帶 類別：集成電路（IC） 配電開關，負載驅動器 描述：IC PWR SWTCH P-CHAN 1:1 PWRSSO12

IPS160HF

Single channel high-side switches; ? 工作電壓范圍為8 V至60 V \n? 最小輸出電流限制：0.7A（IPS161HF）或2.5A（IPS160HF） \n? 啟動時傳輸延遲短 \n? 感應負載快速退磁 \n? 無耗散短路保護（截止） \n? 使用外部電容器的可編程截止延遲時間 \n? 接地?cái)嚅_保護? VCC斷連保護 \n? 熱關斷保護 \n? 欠壓鎖定 \n? 診斷信號：斷開狀態下的開路負載、截止和結點熱關斷 \n? 設計符合IEC 61131-2標準 \n? PowerSSO12 封裝;

IPS160HF（Iout = 2.4A）和IPS161HF（Iout = 0.6A）為單片器件，可驅動電容性、電阻性或電感性負載，且一側接地。\n\n 60 V的工作范圍和Ron = 60mΩ，結合擴展的診斷功能（空載、過載、過熱）和啟動時<60 us的傳輸延遲時間（C型和D型接口啟用3級），使此類IC 適用于更高SIL等級的安全應用。\n\n 內置的過載和熱關機保護功能可確保IC、應用和負載免受電氣和熱過載的影響。\n\n 此外，為了使輸出短路時的功耗最小化，采用低耗散短路保護（截止）來限制輸出平均電流值和由此引起的器件過熱。\n\n 截止延遲時間可以通過焊接外部電容器來設置，也可以通過引腳4（CoD）上的電阻器來禁用。\n\n DIAG通用診斷開漏引腳報告處于斷開狀態、截止（過載）和熱關斷的開路負載。\n\n

IPS160HF

Single channel high-side switches

IPS160HFTR

Single channel high-side switches

IPS160HTR

Single high-side switch

IPS160HFTR

Package：12-LSOP（0.154"，3.90mm 寬）裸露焊盤；包裝：卷帶（TR）剪切帶（CT）Digi-Reel? 得捷定制卷帶 類別：集成電路（IC） 配電開關，負載驅動器 描述：SINGLE CHANNEL HIGH-SIDE SWITCHE

IPS160HTR

Package：12-PowerLSOP（0.154"，3.90mm 寬）；包裝：卷帶（TR）剪切帶（CT）Digi-Reel? 得捷定制卷帶 類別：集成電路（IC） 配電開關，負載驅動器 描述：IC PWR SWTCH P-CHAN 1:1 PWRSSO12