描述 Description

The Gunning Transceiver Logic - Transceiver Voltage Clamps (GTL-TVC) provide high-speed voltage translation with low ON-state resistance and minimal propagation delay. The GTL2002 provides 2 NMOS pass transistors (Sn and Dn) with a common gate (GREF) and a reference transistor (SREF and DREF). The device allows bidirectional voltage translations between 1.0 V and 5.0 V without use of a direction pin.
When the Sn or Dn port is LOW the clamp is in the ON-state and a low resistance connection exists between the Sn and Dn ports. Assuming the higher voltage is on the Dn port, when the Dn port is HIGH, the voltage on the Sn port is limited to the voltage set by the reference transistor (SREF). When the Sn port is HIGH, the Dn port is pulled to VCC by the pull-up resistors. This functionality allows a seamless translation between higher and lower voltages selected by the user, without the need for directional control.
All transistors have the same electrical characteristics and there is minimal deviation from one output to another in voltage or propagation delay. This is a benefit over discrete transistor voltage translation solutions, since the fabrication of the transistors is symmetrical. Because all transistors in the device are identical, SREF and DREF can be located on any of the other two matched Sn/Dn transistors, allowing for easier board layout. The translator's transistors provide excellent ESD protection to lower voltage devices and at the same time protect less ESD-resistant devices.

特性 Features

2-bit bidirectional low voltage translator
Allows voltage level translation between 1.0 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V, 3.3 V and 5 V buses, which allows direct interface with GTL, GTL+, LVTTL/TTL and 5 V CMOS levels
Provides bidirectional voltage translation with no direction pin
Low 6.5 Ω ON-state resistance (Ron) between input and output pins (Sn/Dn)
Supports hot insertion
No power supply required; will not latch up
5 V tolerant inputs
Low standby current
Flow-through pinout for ease of printed-circuit board trace routing
ESD protection exceeds 2000 V HBM per JESD22-A114 and 1000 V CDM perJESD22-C101
Packages offered: SO8, TSSOP8 (MSOP8), VSSOP8, XQFN8

應用 Application

需要雙向或單向電壓電平轉換（從1.0 V和5.0 V之間的任意電壓到1.0 V和5.0 V之間的任意電壓）的任何應用
無方向引腳的開漏結構非常適合雙向低電壓（例如，1.0 V、1.2 V、1.5 V或1.8 V）處理器I2C總線端口變換至普通3.3 V或5.0 V I2C總線信號電平或GTL/GTL+變換至LVTTL/TTL信號電平。