[CHENGPIN]

GENERAL DESCRIPTION

The CP8056 series is a family of low-cost, high speed, high noise immunity, EPROM/ROM-based 8-bit CMOS microcontrollers. It employs a RISC architecture with only 42 instructions. All instructions are single cycle except for program branches which take two cycles. The easy to use and easy to remember instruction set reduces development time significantly.

The CP8056 series consists of Power-on Reset (POR), Brown-out Reset (BOR), Power-up Reset Timer (PWRT), Oscillator Start-up Timer(OST), Watchdog Timer, EPROM/ROM, SRAM, tri-state I/O port, I/O pull-high/open-drain/pull-down control, Power saving SLEEP mode, real time programmable clock/counter, Interrupt, Wake-up from SLEEP mode, and Code Protection for EPROM products. There are four oscillator configurations to choose from, including the power-saving LP (Low Power) oscillator and cost saving RC oscillator. The CP8056 address 1K×13 of program memory.

The CP8056 can directly or indirectly address its register files and data memory. All special function registers including the program counter are mapped in the data memory.

FEATURES

? Only 42 single word instructions

? All instructions are single cycle except for program branches which are two-cycle

? 13-bit wide instructions

? All ROM/EPROM area GOTO instruction

? All ROM/EPROM area subroutine CALL instruction

? 8-bit wide data path

? 5-level deep hardware stack

? Operating speed: DC-20 MHz clock input

DC-100 ns instruction cycle

? Direct, indirect addressing modes for data accessing

? 8-bit real time clock/counter (Timer0) with 8-bit programmable prescaler

? Internal Power-on Reset (POR)

? Built-in Low Voltage Detector (LVD) for Brown-out Reset (BOR)

? Power-up Reset Timer (PWRT) and Oscillator Start-up Timer(OST)

? On chip Watchdog Timer (WDT) with internal oscillator for reliable operation and soft-ware watch-dog enable/disable control

? Two I/O ports IOA and IOB with independent direction control

? Soft-ware I/O pull-high/pull-down or open-drain control

? One internal interrupt source: Timer0 overflow; Two external interrupt source: INT pin, Port B input change

? Wake-up from SLEEP by INT pin or Port B input change

? Power saving SLEEP mode

? Programmable Code Protection

? Selectable oscillator options:

- RC: Resistor/Capacitor Oscillator

- XT: Crystal/Resonator Oscillator

- HF: High Frequency Crystal/Resonator Oscillator

- LF: Low Frequency Crystal Oscillator

? Wide-operating voltage range:

- EPROM : 2.3V to 5.5V

- ROM : 2.3V to 5.5V