特性 Features

In-Line Surge Protector Keeps Your 10G Ethernet Network Equipment Safe

Ideal for home/corporate security systems, home theaters, trade shows and other digital signage

applications, the B110-SP-10G protects connected network equipment from damage caused by

electrostatic discharge (ESD), power surges and cable discharge events. Just connect it between your

network source and device using Cat5/5e/6/6a/8 cables and ground it with the included wire. Note: Surge

protection is unidirectional e.g. from source to device or device to source. Two B110-SP-10G surge

protectors, connected in a series, are required to protect both the source and the connected device.

Your Last Defense Against Intruding Voltage Spikes

Solid-state silicon-avalanche diode technology features low clamping voltage, providing superior

protection against ESD and super-fast response time under one nanosecond. Gas discharge modules on

all four twisted pairs protect each wire from surges or spikes by dissipating the voltage transient through a contained plasma gas. The B110-SP-10G meets the following IEC regulations: IEC 61000-4-2 (8K/15kV),

IEC 61000-4-5 2kA (8/20μs), 6kV (8/20μs) and IEC 61000-4-4 (2kV)

Ready to Use Right from the Package, So You Can Plug and Play Immediately

This in-line surge protector supports data transmission speeds up to 10 Gbps without signal degradation.

No software, drivers or external power supply is required. The compact metal housing is designed to

endure in applications where static discharge is likely to occur. Mounting hardware is included for

convenient installation where needed. Be sure the distance between the B110-SP-10G and the equipment

it is protecting is no more than 330 feet.

TAA-Compliant for GSA Schedule Purchases

The B110-SP-10G is compliant with the Federal Trade Agreements Act (TAA), which makes it eligible for

GSA (General Services Administration) Schedule and other federal procurement contracts.