特性 Features

■Threaded barrel, M30 x 1.5

■Stainless steel, 1.4571

■For temperatures up to +70 °C

■Functions only with Ni25‐CQ40…and Ni40‐

CQ80…

■DC 3-wire, 10…30 VDC

■NO contact, PNP output

■M12 x 1 male connector

Functional principle

The sensors must be operated with an EM30-

AP6X2-H1141/S1102 signal processor. The

switching distance is set using a potentiometer

(continuous) on the signal processor. This is

located under a cover screw next to the LED.

Where possible, the switching distance must

be set at operating temperature. When setting

the switching distance at room temperature, the

temperature sensitivity of the sensor system

must be taken into account.

Setting:

1. Place the target (steel, min. 1 mm thick,

square, edge length min. 3x rated switching

distance) at a safe switching distance in front of

the sensor

2. Turn the potentiometer counterclockwise until

the LED lights up green

3. Turn the potentiometer clockwise until the

LED lights up yellow

4. Perform functional checks in the operating

state